# As a general advice, if something seems ambiguous, just give it a try. # help(, ]) # Further help to a specific topic. # help(error) # List of implemented errors. # help(command) # Short explanations of the available commands. To do this, you need the 60213 60215 Central Station that has been offered since. Operating a model railroad is thereby even more realistic and closer to the prototype. The Märklin 'World of Operation' with the mfx+ decoder is now available for operation close to the prototype. # help(syntax) # Description of the syntax of ECoSNet. RocRail&BiDiB&RailCom - YouTube RocRail&BiDiB&RailCom 2,637 views 8 Dislike Share Alex Labunichev 22 subscribers Rocrail BiDiB. Märklin accepted this and developed the mfx decoder further. # help(basic) # Basic ECoSNet protocol description. # help(intro) # Introduction to the ECoSNet interface. Telnet 15471 help ( ) # Online help for the ECoSNet 0.5 implementation of your ECoS2 4.1.2 # About help: # help() # This help. The "Interface Id" is blank as the default controller (here an ECoS) is used. Note the address of 18 on the Rocrail Sensor Interface screen, for the 2nd sensor of S88-2. The addressing in Rocrail differs from the addressing in ECoS.įor S88-1 the Rocrail addresses are 1 through 16, for S88-2 the addressing starts with 17 through 32, S88-3 would use address 33 - 48, etc. Ich habe Rocrail wegen der Railcom Unterstützung gewählt und bin mit den ersten Tests ganz happy. Here are the corresponding settings in Rocrail. Meine DR5000 arbeitet problemlos mit Rocrail und ebenfalls auch die Steuerung über die WLAN Maus von Roco. You can see that the same 3 sensors have a state = 1 (active). This is a picture of the Rocrail Sensor monitor. You can see that 3 sensors (2, 3 and 4) of S88-1 show a status of occupied. RailCom - Use Id tags on your JMRI, Rocrail, Etc., Panel To See What Loco Is In A Specific Block - Great For Dispatchers And Hidden Staging Yards. You can see that two S88 modules have been added to the ECoS. Currently Rocrail defaults to 16 ports, thus continuous addresses are not possible.Īdd the S88 bus to your ECoS (screen shot from a ECoS II (version 4.0.2)), follow ECoS instructions – Section 22: S88 Bus configuration. Note: The ECoS differentiates between 8 and 16 port S88 modules.
0 Comments
Leave a Reply. |